![]() ![]() ![]() Now, when the Group cue is started, all the Audio cues within it will load, and thus be subject to any Fade cues which target the Group.Dragging the fade handles left and right will set. In the Basics tab for the Group cue and for each Audio cue, make sure the Auto-load check box is checked. Tapping the Fades button will enable or disable the optional integrated fade in and fade out editing handles.Create your Group cue for preshow music, with all the cues set to auto-follow, and all levels set as you like them at the “loud” level.The secret lies in this fact: Fade cues can only fade levels on a target cue which is either running, paused, or loaded. When this happens, the following song starts off playing at its original volume, which is louder, non announcement level. ![]() Everything is great until that one night when you fade down during one song, and then the song ends and the next song begins before the fade back up. Another common need with preshow, however, is not quite so simple, and that’s the case of lowering the level of preshow for an announcement, and then fading it back up. Be sure to also apply the cross-fading function to your playlists. In the Mode tab, make sure to turn on 'Start all children simultaneously.' 3. It will set you back much less than hiring a professional DJ, and is well worth the. Set the audio levels of this first track will begin with and fade from in the Device & Levels tab. Taking that off the last track and enabling the 'do not continue' command was what I needed to do for the Fade and Stop cue to be on standby. Drag your first audio track into QLab to create Audio Cue 1. Lots of folks like to use a Group cue full of Audio cues set to auto-follow for preshow music, and then use a single Fade cue targeting the Group to fade out and stop the preshow music when necessary. I contacted the support team of Qlab and they noted that the last track in my playlist had the 'auto follow' command with nowhere to go. By default this is -60 so if that has not been changed, set your Audio cues to -59. ![]()
0 Comments
Leave a Reply. |